ZyXEL Communications 650 Series User Manual
Prestige 650 Series User’s Guide
26-6
Internet
Access
Table 26-2 Menu 4 Internet Access Setup
FIELD DESCRIPTION
EXAMPLE
Multiplexing
Press [
SPACE BAR
] to select the method of multiplexing used
by your ISP. Choices are VC-based or LLC-based.
LLC-based
VPI #
Enter the Virtual Path Identifier (VPI) assigned to you.
8
VCI #
Enter the Virtual Channel Identifier (VCI) assigned to you.
35
ATM QoS Type
Press [SPACE BAR] and select CBR (Continuous Bit Rate) to
specify fixed (always-on) bandwidth. Select UBR (Unspecified
Bit Rate) for applications that are non-time sensitive, such as e-
mail. Select VBR (Variable Bit Rate) for bursty traffic and
bandwidth sharing with other applications.
specify fixed (always-on) bandwidth. Select UBR (Unspecified
Bit Rate) for applications that are non-time sensitive, such as e-
mail. Select VBR (Variable Bit Rate) for bursty traffic and
bandwidth sharing with other applications.
UBR
Peak Cell Rate
(PCR)
This is the maximum rate at which the sender can send cells.
Type the PCR.
Type the PCR.
0
Sustain Cell Rate
(SCR)= 0
Sustained Cell Rate is the mean cell rate of a bursty, on-off
traffic source that can be sent at the peak rate, and a parameter
for burst-type traffic. Type the SCR; it must be less than the
PCR.
traffic source that can be sent at the peak rate, and a parameter
for burst-type traffic. Type the SCR; it must be less than the
PCR.
0
Maximum Burst Size
(MBS)= 0
Refers to the maximum number of cells that can be sent at the
peak rate. Type the MBS. The MBS must be less than 65535.
peak rate. Type the MBS. The MBS must be less than 65535.
0
My Login
Configure the My Login and My Password fields for PPPoA and
PPPoE encapsulation only. Enter the login name that your ISP
gives you. If you are using PPPoE encapsulation, then this field
must be of the form
PPPoE encapsulation only. Enter the login name that your ISP
gives you. If you are using PPPoE encapsulation, then this field
must be of the form
where domain identifies your
PPPoE service name.
N/A
My Password
Enter the password associated with the login name above.
N/A
ENET ENCAP
Gateway
Gateway
Enter the gateway IP address supplied by your ISP when you
are using ENET ENCAP encapsulation.
are using ENET ENCAP encapsulation.
N/A
Idle Timeout
This value specifies the number of idle seconds that elapse
before the Prestige automatically disconnects the PPPoE
session.
before the Prestige automatically disconnects the PPPoE
session.
0
IP Address
Assignment
Assignment
Press [
SPACE BAR
] to select Static or Dynamic address
assignment.
Dynamic
IP Address Enter the IP address supplied by your ISP if applicable.
N/A