RTS RT-2M Leaflet

See the entire system diagram on reverse side.

Step 1. Cable the Trunk Supervisor/TrunkEdit PC to the 
RT-2M.

In Trunk Supervisor, you must designate 

the intercom and port number the RT-2M  
sends the test signal over.

To cable the Trunk Supervisor/TrunkEdit PC to the 
RT-2M, do the following:

Using the included cable, connect a COM port  on 
the Trunk Supervisor computer to the RS-232 
Interface connector on the rear panel of the RT-2M.

Step 2. Cable the RT-2M to the Frame.

To cable the RT-2M to the Frame, do the following:

Using the appropriate connector defined below, connect the 
RT-2M to the Frame:

Connect the other end of the connector to the trunking 

connection port as defined in the Trunk Supervisor software. 

RJ-12

Plug pins 2 and 5 into the Ch 1 input connector terminals.

Plug pins 3 and 4 into the Ch 1 output connector terminals.

DB-9

Plug pins 7 and 8 into the Ch 1 input connector terminals

Plug pins 4 and 5 into the Ch 1output connector terminals.

RT-2M Unit

DB-9 Cable

LIT000306000 Rev. A

11/2008