Adtran MX2800 M13 User Manual

MX2800 M13 Multiplexer User Manual

Configuration, Section 3

61200290L1-1G

    3-13

 

The following options are available for detection:

• Disabled is used to cause the T1/E1 lines to ignore in-band loop-up and loop-down codes.

• CSU is used to cause the channel to loop up or loop down when it receives a CSU loop-up or loop-down 

pattern for more than 5 seconds.

• NIU is used to cause the channel to loop up or loop down when it receives an NIU loop-up or loop-down 

pattern for more than 5 seconds.

Select Set Multiple

 

to set a contiguous group or all of the T1/E1s to the same value at the same time. Refer 

on page 3-9 for a description of the

 

Set Multiple option.

T1/E1 Circuit Protection determines which circuit is allowed to initiate a protection switch if a failure in 
the circuitry for that channel is detected. See 

on page 3-14. If a T1/E1 is set to 

Disabled

, the 

failure of the circuitry of that one channel does not cause a protection switch. If set to 

Enabled

, the failure 

of a channel causes a protection switch to occur if the Protection Threshold setting in this menu is 
exceeded.