Allied Telesis AT-2973T User Manual
AT-2973SX, AT-2973T, and AT-2973T/4 NetExtreme II Family Adapters Installation and User’s Guide
89
Note
You must physically install a network device driver before the
Broadcom NetXtreme II Controller can be used with your Windows
Operating System. There is no installation CD. You must download
the drivers from the Allied Telesis website at
www.alliedtelesis.com/support/software. After you have
accessed this website, enter the model number in the Search by
Product Name box and then click Find to view the current list of
documents and drivers.
Broadcom NetXtreme II Controller can be used with your Windows
Operating System. There is no installation CD. You must download
the drivers from the Allied Telesis website at
www.alliedtelesis.com/support/software. After you have
accessed this website, enter the model number in the Search by
Product Name box and then click Find to view the current list of
documents and drivers.
Note
To use the TCP/IP Offload Engine (TOE), you must have Windows
Server 2003 with Service Pack 2 (SP2) and a license key
preprogrammed in the hardware. If supported, for iSCSI you only
need a license key.
Server 2003 with Service Pack 2 (SP2) and a license key
preprogrammed in the hardware. If supported, for iSCSI you only
need a license key.
Using the
Installer
The Installer has a graphical interactive installation mode. To install the
AT-2973SX, AT-2973T, and AT-2973T/4 drivers on a Windows Operating
System, do the following:
AT-2973SX, AT-2973T, and AT-2973T/4 drivers on a Windows Operating
System, do the following:
1. When the Found New Hardware Wizard appears, click No, not this
time.
See Figure 13 on page 90 for the Found New Hardware Wizard Page.