Adtran 1000R Series User Manual
Command Reference Guide
IKE Policy Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
1272
respond [main | aggressive | anymode]
Use the respond command to allow the IKE policy to respond to negotiations by a peer. Use the no form
of this command to allow the policy to only initiate negotiations.
of this command to allow the policy to only initiate negotiations.
Syntax Description
main
Specifies to respond only to main mode.
aggressive
Specifies to respond only to aggressive mode.
anymode
Specifies to respond to any mode.
Default Values
By default, respond to any mode is enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Series units.
Command History
Release 4.1
Command was introduced.
Functional Notes
By using the initiate and respond commands, you can configure the IKE policy to initiate and respond,
initiate only, or respond only. It is an error if you have both initiate and respond disabled.
initiate only, or respond only. It is an error if you have both initiate and respond disabled.
Usage Examples
The following example configures the router to initiate and respond to IKE negotiations:
(config-ike)#respond anymode
(config-ike)#initiate main