Adtran 1000R Series User Manual
Command Reference Guide
Line (Telnet) Interface Config Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
553
L
INE
(T
ELNET
) I
NTERFACE
C
ONFIG
C
OMMAND
S
ET
To activate the Line (Telnet) Interface Configuration mode, enter the line telnet command specifying a
Telnet session(s) at the Global Configuration mode prompt. For example:
Telnet session(s) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#line telnet 0 4
(config-telnet0-4)#
#configure terminal
(config)#line telnet 0 4
(config-telnet0-4)#
You can select a single line by entering the line telnet command followed by the line number (0-4). For
example:
example:
>enable
#configure terminal
(config)#line telnet 2
(config-telnet2)#
#configure terminal
(config)#line telnet 2
(config-telnet2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
of this guide. For more information, refer to the sections listed below:
All other commands for this command set are described in this section in alphabetical order.