Actiontec electronic GT701 User Manual
38
Actiontec USB/Ethernet DSL Modem User Manual
39
Chapter 4 Using Advanced Setup
The Unnumbered Mode feature automatically configures the appropriate
IP
rout-
ing for the
IP
Address block. The
IP
route will bypass
NAT
, enabling the public
IP
s
to be routed WAN
-to-
LAN
, as well as
LAN
-to-
WAN
.
☞
Note: The
IP
Address information should be obtained from the
ISP
when purchasing a block of public static
IP
address. Contact
the
ISP
if this information was not received.
VIP Mode - This feature is used in conjunction with Unnumbered Mode. When
VIP
Mode is activated, the Modem uses
NAT
for private
IP
addressing for the local area
network (
LAN
), allowing both public
IP
addressing and private
IP
addressing to be
configured to the
LAN
simultaneously, while the
DHCP
server is reserved for private
IP
addressing. All computers using public
IP
addresses with Unnumbered Mode must
have the public
IP
addresses statically assigned. Enter the static IP address in the text
boxes below “Unnumbered IP Address.”
After configuring your settings, click Next, then click Save and Restart to make all
changes permanent.
changes permanent.
LAN IP Address
Selecting LAN IP Address in the “Configuring the Advanced Settings” screen gen-
erates the “
erates the “
LAN IP
Address” screen.
The values in the “Device
IP
Address” and “Device
LAN
Netmask” text boxes are
the
IP
address and subnet mask of the Modem as seen on the network. These val-
ues can be modified for your
LAN
network, but Actiontec recommends keeping the
default factory settings (
IP
address
192.168.0.1;
subnet mask
255.255.255.0
).