Cisco Systems AIRCAP3602ITK9 User Manual

Page of 40
10
 
Note
You cannot edit or query any access point using the controller CLI if the name of the access 
point contains a space.
Note
Make sure that the controller is set to the current time. If the controller is set to a time that 
has already occurred, the access point might not join the controller because its certificate may 
not be valid for that time.
Access points must be discovered by a controller before they can become an active part of the network. 
The access point supports these controller discovery processes:
Layer 3 CAPWAP discovery—Can occur on different subnets than the access point and uses IP 
addresses and UDP packets rather than MAC addresses used by Layer 2 discovery.
Locally stored controller IP address discovery—If the access point was previously joined to a 
controller, the IP addresses of the primary, secondary, and tertiary controllers are stored in the 
access point’s non-volatile memory. This process of storing controller IP addresses on an access 
point for later deployment is called priming the access point. For more information about priming, 
see the “Performing a Pre-Installation Configuration” section on page 11.
DHCP server discovery—This feature uses DHCP option 43 to provide controller IP addresses to 
the access points. Cisco switches support a DHCP server option that is typically used for this 
capability. For more information about DHCP option 43, see the “Configuring DHCP Option 43 
and DHCP Option 60” section on page 37.
DNS discovery—The access point can discover controllers through your domain name server 
(DNS). For the access point to do so, you must configure your DNS to return controller IP 
addresses in response to CISCO-CAPWAP-CONTROLLER.localdomain, where localdomain is 
the access point domain name. Configuring the CISCO-CAPWAP-CONTROLLER provides 
backwards compatibility in an existing customer deployment. When an access point receives an IP 
address and DNS information from a DHCP server, it contacts the DNS to resolve 
CISCO-CAPWAP-CONTROLLER.localdomain. When the DNS sends a list of controller IP 
addresses, the access point sends discovery requests to the controllers.
Preparing the Access Point
Before you mount and deploy your access point, we recommend that you perform a site survey (or use 
the site planning tool) to determine the best location to install your access point.
You should have the following information about your wireless network available:
Access point locations.