Cisco Systems AIRCAP3602ITK9 User Manual

Page of 40
22
 
The access point is still connected to the same controller, and the global syslog server IP address 
configuration on the controller has been changed using the config ap syslog host global 
syslog_server_IP_address
 command. In this case, the controller sends the new global syslog server 
IP address to the access point.
The access point is still connected to the same controller, and a specific syslog server IP address 
has been configured for the access point on the controller using the config ap syslog host specific 
Cisco_AP syslog_server_IP_address
 command. In this case, the controller sends the new specific 
syslog server IP address to the access point.
The access point is disconnected from the controller and joins another controller. In this case, the 
new controller sends its global syslog server IP address to the access point. 
Whenever a new syslog server IP address overrides the existing syslog server IP address, the old 
address is erased from persistent storage, and the new address is stored in its place. The access 
point also starts sending all syslog messages to the new IP address provided the access point can 
reach the syslog server IP address.
You can configure the syslog server for access points and view the access point join information only 
from the controller CLI.
A detailed explanation of the join process is on Cisco.com at the following URL:
12  
Declarations of Conformity and Regulatory Information
This section provides declarations of conformity and regulatory information for the Cisco Aironet 
3602 series Access Point and any additional modules that can be installed into the Cisco Aironet 3602 
series Access Point. You can find additional information at this URL:
www.cisco.com/go/aironet/compliance
Manufacturers Federal Communication Commission Declaration of 
Conformity Statement
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE