Compex Technologies 18A User Manual
172
Viewing the Webcam
If you see the message read: “Please change its status in Webcam
Setup”, it shows that you have not enabled the webcam setup. To enable it,
refer to the previous section in configuring the webcam setup.
refer to the previous section in configuring the webcam setup.
Webcam View
Under the HOME USER FEATURES command
menu, click on Webcam
View.
Property Button
Click this button to adjust size, display
parameters and filters of your screen.
menu, click on Webcam
View.
Property Button
Click this button to adjust size, display
parameters and filters of your screen.
Capture Button
Click this button to capture a still picture from
the video feed. Right-click on the still picture
and select “Save Picture As…” from the
menu.
Clicking the Capture button again will allow
you to refresh the still picture to a new
instant.
Click this button to capture a still picture from
the video feed. Right-click on the still picture
and select “Save Picture As…” from the
menu.
Clicking the Capture button again will allow
you to refresh the still picture to a new
instant.
Left/Up/Center/Down/Right Button
These buttons allow you to adjust the position
of your webcam if you are using a tracker
pod.
Webcam Pan/Tilt Button
This button allows you to adjust the position of
your Quickcam Sphere/Orbit webcam.
These buttons allow you to adjust the position
of your webcam if you are using a tracker
pod.
Webcam Pan/Tilt Button
This button allows you to adjust the position of
your Quickcam Sphere/Orbit webcam.