Lucent Technologies 6000 User Manual
5-22
Preliminary January 4, 2001
MAX 6000/3000 Network Configuration Guide
Configuring Frame Relay
Concentrating incoming calls onto Frame Relay
Concentrating incoming calls onto Frame Relay
LAN Adrs=10.111.112.113/24
Session options
FR Direct=Yes
FR Prof=
FR Dlci=16
Settings in a RADIUS profile
Following are the relevant RADIUS attributes for FR Direct connections:
Parameter
Specifies
Encaps
Specifies the supported encapsulation protocol. Must be set to
PPP, MP, or MPP for Frame Relay Direct connections.
PPP, MP, or MPP for Frame Relay Direct connections.
FR Direct
Enables/disables FR-Direct mode for this connection.
FR Prof
Specifies the name of the Frame Relay profile that defines the
datalink.
datalink.
FR Dlci
DLCI assigned in a Connection profile to a next hop on the
specified interface. Multiple FR-Direct Connection profiles can
refer to the same DLCI in this setting.
specified interface. Multiple FR-Direct Connection profiles can
refer to the same DLCI in this setting.
Route IP
Enables/disables IP routing for this connection. Must be enabled
for the MAX to send data back to the appropriate PPP caller.
for the MAX to send data back to the appropriate PPP caller.
LAN Adrs
Specifies the PPP caller’s IP address. As the MAX receives return
packets for many Frame Relay Direct connections on the same
DLCI, it uses this address to determine which PPP caller should
receive the return packets.
packets for many Frame Relay Direct connections on the same
DLCI, it uses this address to determine which PPP caller should
receive the return packets.
Attribute
Value
Framed-Protocol (7)
The encapsulation protocol. Must be set to PPP (1), MP (262), or
MPP (256) for FR-Direct connections.
MPP (256) for FR-Direct connections.
Ascend-FR-Direct (219)
Enables/disables FR-Direct mode for this connection. FR-Direct-
No (0) is the default. Set to FR-Direct-Yes (1) for FR-Direct
connections.
No (0) is the default. Set to FR-Direct-Yes (1) for FR-Direct
connections.
Ascend-FR-Direct-
Profile (220)
Profile (220)
Name of the Frame-Relay profile that defines the datalink.
Ascend-FR-Direct-
DLCI (221)
DLCI (221)
DLCI assigned in a Connection profile to a next hop on the
specified interface. Multiple FR-Direct Connection profiles can
refer to the same DLCI in this setting.
specified interface. Multiple FR-Direct Connection profiles can
refer to the same DLCI in this setting.
Ascend-Route-IP (228)
Enables/disables IP routing for this connection. (IP is enabled by
default. If this attribute is present, it must be set to Route-IP-Yes
to enable the MAX to send data back to the appropriate PPP
caller.
default. If this attribute is present, it must be set to Route-IP-Yes
to enable the MAX to send data back to the appropriate PPP
caller.