Lucent Technologies 6000 User Manual

MAX 6000/3000 Network Configuration Guide

 9-37

configured to acquire its IP address dynamically. For example, the following a sample software 
configuration presumes that the PC has a modem connection to the MAX unit:

Username=victor

Accept Assigned IP=Yes

IP address=Dynamic (or Assigned or N/A)

Netmask=255.255.255.255 (or None or N/A)

Default Gateway=None or N/A

Name Server=10.2.3.55

Domain suffix=abc.com

Baud rate=38400

Hardware handshaking ON

VAN Jacobsen compression ON

To configure the MAX unit to accept dial-in connections from Site B and assign an IP address:

Open Ethernet > Mod Config > WAN Options.

Set the Pool#1 Start parameter to specify the start address of the pool, and set the Pool#1 
Count parameter to specify the number of contiguous addresses the pool includes. For 
example:

Ethernet

Mod Config

WAN options…

Pool#1 start=10.12.253.1

Pool#1 count=126

Pool#1 name=Engineering Dept.

Pool only=Yes

Pool Summary=Yes

Open the Ether Options subprofile, then set the Proxy Mode parameter to Yes.

Ether options…

Proxy Mode=Yes

Exit the profile and, at the exit prompt, select the

 

exit and accept

 option.

Open the Answer profile and set the Assign Adrs parameter to enable dynamic address 
assignment and set the PPP Options > Route IP parameter to enable IP routing:

Ethernet

Answer

Assign Adrs=Yes

PPP options…

Route IP=Yes

Exit the profile and, at the exit prompt, select the

 

exit and accept

 option.

Open a Connection profile for the dial-in user.

Set the Station parameter to specify the user’s name, set the Active parameter to activate 
the profile, and specify the desired encapsulation options. For example:

Ethernet

Connections

Station=victor

Active=Yes

Encaps=PPP