Lucent Technologies 6000 User Manual

MAX 6000/3000 Network Configuration Guide

 12-13

PPP options...

Route IPX=Yes

Recv Auth=Either

Exit the profile and, at the exit prompt, select the exit and accept option.

Open the Connection profile you will use to configure the dial-in user’s connection.

Set the Station parameter to specify the dial-in client’s login name, and activate the profile 
by setting Active to Yes. For example:

Ethernet

Connections

Station=scottpc

Active=Yes

Enable IPX routing:

Route IPX=Yes

Select PPP encapsulation and configure the dial-in client’s password. For example:

Encaps=PPP

Encaps options...

Recv PW=scottpw

10 Open the IPX Options subprofile and specify a dial-in client:

IPX options...

Peer=Dialin

IPX RIP=None

11 Exit the profile and, at the exit prompt, select the exit and accept option.

Following is a RADIUS profile comparable to the previous Connection profile:

scottpc Password = "scottpw"

   Service-Type = Framed-User, 

   Framed-Protocol = MPP,

   Ascend-Route-IPX = Route-IPX-Yes,

   Ascend-IPX-Peer-Mode = IPX-Peer-Dialin

In this example, the MAX unit connects to an IPX network that supports both servers and 
clients and connects with a remote site that also supports both servers and clients, as shown in 
Figure 12-2.