Manualsbrain.com
  1. Manuals
  2. Brands
  3. Lantronix
  4. 900-422
  5. User Manual

Lantronix 900-422 User Manual

Download
Page of 87
 
XPress DR+ User Guide 
47 
7: Setup Mode: Server Configuration 
This chapter explains how to configure the network settings. 
Note:
 Current values display in parentheses. 
Server Configuration (Option 0) 
The unit’s basic network parameters display when you select Server configuration 
(option 0). The IP Address, Set Gateway IP Address, and Netmask fields display the 
current values. 
Figure 7-1. Server Settings 
IP Address : (000) .(000) .(000) .(000) 
Set Gateway IP Address (N) 
Netmask: Number of Bits for Host Part (0=default)  (0) 
Change telnet config password (N) 
IP Address  
If DHCP is not used to assign IP addresses, enter the IP address manually. The IP 
address must be set to a unique value in the network. Enter each octet and press Enter 
between each section. The current value displays in parentheses. 
IP Address : ( 0) ( 0) ( 0) ( 0) _ 
If DHCP is used, the third octet of the IP address sets the BootP/DHCP/AutoIP options. 
The following table shows the bits you can manually configure to force the XPress DR+ 
to disable AutoIP, DHCP, or BootP. To disable an option, set the appropriate bit. 
Table 7-1. BootP/DHCP/AutoIP options 
Options 
Bit 
Value 
AutoIP 0 1 
DHCP 1 2 
BootP 2 4 
For example, if the third octet is 0.0.5.0, the AutoIP and BootP options are disabled; only 
DHCP is enabled. (The value 5 results from adding the binary equivalents of 0 and 2.) 
This is the most common setting when using DHCP.