Lantronix 900-332 User Manual
Configuration Via Serial Mode or Telnet Port
5-22
WiPort™
User
Guide
Disable Port 77FEh (N) ? _
The default setting is the N (No) option, which enables remote configuration. As a
result, configure the unit by using DeviceInstaller, web pages, Telnet, or serial
configuration.
result, configure the unit by using DeviceInstaller, web pages, Telnet, or serial
configuration.
The Y (Yes) option disables remote configuration and web sites.
Note:
The Y (Yes) option disables many of the GUI tools for configuring the
unit, including the embedded Web-Manager tool.
Disable Web Server
The Y (Yes) option disables the web server. This setting defaults to the N (option).
Disable Web Server (N) ? _
Disable Web Setup
The Y (Yes) option disables configuration via the Web-Manager. This setting defaults
to the N (option).
to the N (option).
Disable Web Setup (N) ? _
Disable ECHO Ports
This setting controls whether the serial port echoes characters it receives. The
current value is displayed in parentheses.
current value is displayed in parentheses.
Disable ECHO ports (Y) ? _
Enable Enhanced Password
This setting defaults to the N (option), which permits a 4-character password
protecting Setup Mode by means of Telnet and web pages.
protecting Setup Mode by means of Telnet and web pages.
Enable Enhanced Password (Y) ? _
The Y (Yes) option allows an extended security password of 16-characters for
protecting Telnet access.
protecting Telnet access.
Disable Port 77F0 (Hex)
Port 77F0 is a setting that allows a custom application to query or set the eleven
WiPort configurable pins when they are functioning as general purpose I/O (GPIO).
Disable this capability, if desired, for security purposes.
WiPort configurable pins when they are functioning as general purpose I/O (GPIO).
Disable this capability, if desired, for security purposes.
Disable Port 77F0h ? _
The default setting, the N (No) option, enables GPIO control. The Y (Yes) option
disables the GPIO control interface.
disables the GPIO control interface.
Factory Defaults
Select 7 Factory Defaults from the Change Setup menu to reset the unit’s Channel
1 configuration, Channel 2 configuration, E-mail settings, and Expert settings to the
factory default settings. The server configuration settings for IP address, gateway IP
address, and netmask remain unchanged. The configurable pins’ settings also
remain unchanged. The specific settings that this option changes are listed below:
1 configuration, Channel 2 configuration, E-mail settings, and Expert settings to the
factory default settings. The server configuration settings for IP address, gateway IP
address, and netmask remain unchanged. The configurable pins’ settings also
remain unchanged. The specific settings that this option changes are listed below: