Microsoft MN-500 User Manual
setup
Using the Setup Wizard
This chapter will guide you through the setup process for your Microsoft
®
Broadband
Networking Wireless Base Station. The procedures described in the Typical Setup
section of this chapter will help you set up your base station by using the wizard on the
Setup CD. Typical Setup is recommended because the Setup Wizard identifies and
configures a variety of Internet and wireless network settings.
section of this chapter will help you set up your base station by using the wizard on the
Setup CD. Typical Setup is recommended because the Setup Wizard identifies and
configures a variety of Internet and wireless network settings.
To use the Typical Setup steps, you will need:
O
A computer that has an Ethernet port and is running Microsoft Windows
®
XP,
Windows Millennium Edition, Windows 98, or Windows 98 SE operating system.
O
An external broadband modem with an Ethernet port.
You should not use the Typical Setup steps if any of the following apply to you.
O
You want to set up the base station from a Windows 2000–based computer. See
Chapter 3.
Chapter 3.
O
You don’t have a computer with an Ethernet port. See “Setting Up the Base Station
Wirelessly” later in this chapter.
Wirelessly” later in this chapter.
O
You want to set up the base station from a computer that isn’t running Windows.
See Chapter 3.
See Chapter 3.
O
You don’t want to run the Setup Wizard to set up the base station. See Chapter 3.
O
You have an existing network with a base station, gateway, or router, and want to
use this base station as an access point. See the MN-500: Base Station
Configuration Guide on the Setup CD.
use this base station as an access point. See the MN-500: Base Station
Configuration Guide on the Setup CD.
2