Panasonic M1111TY0 -FJ User Manual

Page of 145
89
Settings
 2. Input/output signal settings
2-2-1.  Assigning the output signals
The output signals can be assigned to the SDI OUT1 to SDI 
OUT5 connectors and DVI OUT connector.
On the Output sub menu, use [F2] to select the output 
to be set using the Select item.
 Refer to “2-2. Output signal settings”.
Use [F1] to display the Assign sub menu.
Use [F2] to set the type of output signal using the 
Source item.
PGM
An image provided with the wipe, mix, key, 
downstream key or other effect is output at 
the switcher’s main line output.
PVW
This is the preview output that enables the 
next operation to be checked before it is 
executed.
AUX1 to 4
The signals selected by the 4 lines of AUX 
buses (AUX1 to AUX4) are output.
CLN
The clean signal (the image resulting when 
the key, downstream key or other effect 
has been removed from the PGM signal) is 
output.
 Refer to “Assigning the CLN signal”.
MV
The multi view display signals are output.
Multiple input signals and output signals are 
reduced in size and output to one screen.
KeyOut
The key signal is output.
MEM-PVW
In the memory preview mode, the shot 
memory and event memory effects are output 
to preview.
Use [F3] to set the output mode using the Mode item.
Normal
The same signals as the system format 
signals are output.
Down 
Convert
(down-
converter)
This can be selected when the SDI output 
board (option: AV-HS04M7) has been 
connected.
When the system format is 1080/59.94i or 
720/59.94p, the signals are output in the 
480/59.94i format.
When the system format is 1080/50i or 
720/50p, the signals are output in the 576/50i 
format.
When the system format is SD (480/59.94i or 
576/50i), this setting cannot be selected.
 Assigning the CLN signal
Set KEYCLN or DSKCLN as the CLN output.
Press the 
s button to light its indicator, and display the 
Config menu.
Use [F1] to display the Assign sub menu.
Use [F3] to select the type of output signal using the 
CLN item.
Key
The PGM signals minus the key effects are 
output.
The Key, PinP1, PinP2 and DSK effects are 
not added.
DSK
The PGM signal minus the downstream key 
effects are output.
2-2-2.  Setting the SDI output color range
The color range can be set for the SDI output signal images.
 The same setting applies to all the SDI output signals.
On the Output sub menu, use [F5] to set the color range 
using the SDI Limit item.
 Refer to “2-2. Output signal settings”.
Off
The color range is not restricted.
108
The amplitude level of the colors (R, G and 
B) is restricted to 0 % - 108 %.
104
The amplitude level of the colors (R, G and 
B) is restricted to 0 % - 104 %.
100
The amplitude level of the colors (R, G and 
B) is restricted to 0 % - 100 %.