Mobility Electronics P13RR-TEL User Manual

 

Check your installation before powering up the MAGMA expansion 
chassis for the first time. Although the power supply has an over voltage 
protection device built into it, it may not "trip" in time to fully protect a 
device that has been improperly connected, or whose power cable has 
been damaged.   

 

You must apply power to the MAGMA expansion chassis BEFORE you 
power up your computer. This will allow the higher numbered PCI buses 
in the PCI bus hierarchy to be at a stable state when the host system 
issues its master power-on bus reset. In systems that perform automatic 
PCI bus configuration, this will allow the configuration code to recognize 
the PCI bus hierarchy and any attached 
devices.  

There is an On/Off switch on the front panel, as 
well as LED indicators to indicate power status. 
Verify that the green power indicators are ON.  

As your Windows XP/2000 computer starts 
up, you will see a small message box pop-
up in the lower-right corner of the screen to 
alert you that Windows has found new 
hardware.  

You are now ready to go. No drivers are needed. Now go to 

.