NEC NWA-008869-001 User Manual

CHAPTER 5  EXAMPLES OF SETUP ON NETWORKS

NWA-008869-001 Rev.1.0

atch5001.fm

Setting PPPoE
Set the PPPoE interface Ethernet0.1. Specify the ID and password information and authentication response
types (both PAP and CHAP) used to connect to a provider. In this example, “my-router@xxx.nec.com” is
set as the user ID and “8643bca29” is set as the password.

As the IP address of Ehternet0.1, use the one acquired by IPCP.

Setting the route
As the default route, specify the interface Ethernet0.1.

Setting the terminal-side network
Set the IP address of the terminal-side interface FastEthernet0.0. Also, use NAPT so that multiple termi-
nals can establish Internet connections at the same time.

Router (config) # ppp profile biglobe 

Router (config 

− ppp − biglobe) # authentication myname my − router@xxx.nec.com 

  

Router (config 

− ppp − biglobe) # authentication password my − router@xxx.nec.com

   

                              8643bca29 

Router (config 

− ppp − biglobe) # authentication accept chap − pap 

Router (config 

− ppp − biglobe) # exit 

Router (config) # interface Ethernet0.1 

Router (config 

− Ethernet0.1) # encapsulation pppoe 

Router (config 

− Ethernet0.1) # ppp binding biglobe 

Router (config 

− Ethernet0.1) # ip address ipcp 

Router (config 

− Ethernet0.1) # no shutdown 

Router (config 

− Ethernet0.1) # 

Enter

Enter

Enter

Enter

Enter

Enter

Enter

Enter

Enter

Enter

Router (config 

− Ethernet0.1) # exit 

Router (config) # ip route default Ethernet0.1 

Router (config) #

Enter

Enter

Router (config) # interface FastEthernet0.0 

Router (config 

− FastEthernet0.0) # ip address 192.168.1.1/24 

Router (config 

− FastEthernet0.0) # no shutdown 

Router (config 

− FastEthernet0.0) # interface Ethernet0.1 

Router (config 

− Ethernet0.1) # ip napt enable 

Router (config 

− Ethernet0.1) #

Enter

Enter

Enter

Enter

Enter

PPPoE SETUP EXAMPLE