Multi-Tech Systems RF550VPN User Manual
Chapter 2 – Installation
5
Cabling Your RouteFinder
Cabling your RouteFinder requires making the appropriate connections to PCs, Cable
or xDSL modem, analog modem or ISDN TA (optional), AC power and the router. After
your device is properly cabled, you will need to complete your configuration by following
the instructions provided in the following chapter.
or xDSL modem, analog modem or ISDN TA (optional), AC power and the router. After
your device is properly cabled, you will need to complete your configuration by following
the instructions provided in the following chapter.
1.
Turn the power off on all network devices (PCs, cable modems, DSL modems,
analog modems, ISDN TAs, and the router).
analog modems, ISDN TAs, and the router).
2.
Plug one end of a cable into the Ethernet port and other into one of the 4 LAN ports.
(If you have more than one PC, connect the others in the same way to the other LAN
ports).
(If you have more than one PC, connect the others in the same way to the other LAN
ports).
3.
If using an analog modem, connect it to the RF550VPN’s serial port.
4.
Connect a network cable from the DSL modem or cable modem to the WAN port.
5.
Connect the provided power supply cable to the 5VDC power port on the back of the
router. Plug the other end of the power supply into an AC power outlet as shown.
router. Plug the other end of the power supply into an AC power outlet as shown.
You are ready to configure your router and network PCs.