Multi-Tech Systems MT5600BA-V.92 User Manual

Chapter 3 - Using the Front Panel

Multi-Tech Systems, Inc. MT5600BA/BL Series User Guide (S000276E)

Remote C

emote C

emote Co

onf

nfig

igur

ura

tiiiiio

on Opt

n Opt

n Optiiiiio

ons

The following screens are used to configure remote configuration options. For more
information about remote configuration, see Chapter 5, “Remote Configuration.”

ENABLE/DISABLE R.C.

Use the

Æ and

Enter

buttons to turn

remoteconfiguration on or off.

REMOTE CONFIG. PASSWORD.

Use to enter the remote con-

figuration password. To scroll through a list of digits and charac-
ters, press the

ÇÅ

Å and È

È buttons. To go to the next position,

press the

Æ button. To back up or to exit without saving, press

the

Æ button several times. To save the password, press the

Enter

button.

Diag

Diagno

nost

stiiiiic Opt

c Opt

c Optiiiiio

ons

Use the following screens to turn loopback tests on and off.

ANALOG LOOPBACK.

Press the

Æ and

Enter

buttons to start

the analog loopback test. The

TEST IN PROGRESS

screen

appears. To stop the test, press the

Æ and

Enter

buttons again.

DIGITAL LOOPBACK.

Press the

Æ and

Enter

buttons to start

the local digital loopback test. The

TEST IN PROGRESS

screen appears. To stop the test, press the

Æ and

Enter

but-

tons again. Same as the

command.

REMOTE DIGITAL LOOPBACK.

Press the

Æ and

Enter

but-

tons to start the remote digital loopback test. The

TEST IN

PROGRESS

screen appears. To stop the test, press the

Æ and

Enter

buttons again. Same as the

command.

Note:

Digital Loopback and Remote Digital Loopback tests must be performed using AT Commands. The

LCD option to run these tests has been temporarily removed.

Pho

Phone Number

ne Number

ne Number Memo

Memo

Memor

y Opt

Opt

Optiiiiio

ons

Use the following screens to list, enter, and dial stored phone numbers. Up to four
phone numbers can be stored. The number in memory location 0 is used for DTR
dialing, if DTR dialing is enabled. Note

Only 16 characters can be displayed at a time.

To display characters 17–30, press the

È button. To go to the previous screen, press

the

Å button. To go to the next screen, press the Æ

Æ button.

LIST PHONE NUMBERS.

Press the

Æ button several times to

display the phone number stored in each memory location.

ENTER PHONE NUMBERS.

Use to store up to four phone num-

bers in memory locations 0–3. Each number can have up to 30
characters. To scroll through a list of digits and characters, press
the

ÇÅ

Å and È

È buttons. To go to the next position, press the Æ

button. To back up or to exit without saving, press the

Æ button

several times. To save the number, press the

Enter

button.

Same as the

commands.

DIAL STORED NUMBERS.

Press the

Æ and

Enter

buttons to

dial a stored phone number. Same as the

DS=

commands.