Netgear DGN1000-100NAS User Manual

Installing Your Router Manually (Advanced, Mac, and Linux Users)

13

Before you install your wireless modem router, make sure that the Internet Protocol (TCP/IP) 
Property settings on your computer are set to “automatically obtain an IP address” using DHCP 
and “Obtain DNS server address automatically.” You can check these settings by looking at the 
TCP/IP Properties of your Internal Network Connections, which are accessible through the 
Control Panel of your computer. If you are unsure about this, refer to the documentation for your 
computer or see the link to TCP/IP Addressing in 

.

Connect an ADSL filter as shown below.

•

Install an ADSL filter for every telephone that uses the same phone line as your wireless 
modem router. Select the appropriate filter(s) for your wireless setup. 

If you are replacing an existing router, disconnect it completely from your network 
and set it aside before starting to install your new router. 

If you purchased the DGN1000 in a country where an ADSL filter is not 
included, you must acquire one.

1. One-Line Filter: Use with a phone or fax machine.

2. Splitter: Use with a one-line filter to share an outlet with a phone and the wireless 

modem router.

3. Two-Line Filter with Splitter: Use to share an outlet with a phone and the wireless 

modem router.