Nortel Networks 114200-E User Manual
Installing and Operating Passport ARN Routers
2-12
114200-E Rev 00
Figure 2-1.
Verifying Directed Netboot Configuration
If
getcfg
displays the correct information, continue to Step 4. Otherwise,
correct and reenter the
ifconfig
and
bconfig
commands. If you need
assistance, contact your network administrator.
4.
Type the following command and press the Return key to boot the ARN:
boot
5.
Ensure that the ARN boots correctly.
When the ARN boots, its LEDs flash in a particular order. To ensure that the
installation was successful, see “Ensuring a Successful Installation” on
“Ensuring a Successful Installation” on page 3-9.
installation was successful, see “Ensuring a Successful Installation” on
“Ensuring a Successful Installation” on page 3-9.
Note:
If the ARN cannot find a software image file or a configuration file
using the directed netboot procedure, it attempts to netboot once. If the netboot
procedure fails, the ARN tries to local boot once. If all three boot attempts fail,
the ARN continues to try directed netboot, netboot, and local boot until it
boots successfully. If the ARN remains in this loop, follow the steps in
“Interrupting the Boot Process” on
procedure fails, the ARN tries to local boot once. If all three boot attempts fail,
the ARN continues to try directed netboot, netboot, and local boot until it
boots successfully. If the ARN remains in this loop, follow the steps in
“Interrupting the Boot Process” on
.
ARN0080A
$ getcfg
Boot Options
boot image = network
boot config = network
host IP address = 192.32.5.8
image pathname =
"/usr/arnstartup/krnl_arn.exe"
config pathname =
"/usr/arnstartup/config"
Netboot Parameters:
MAU1...None
XCVR2..None
COM1...IP=9.0.0.2, Mask=255.0.0.0, Next Hop=9.0.0.3
COM2...EZ-Install (disabled)
COM3...EZ-Install (disabled)
COM4...EZ-Install (disabled)
COM5...EZ-Install (disabled)