Nortel Networks BCM50a User Manual
252 Appendix G Command Interpreter
N0115791
ifconfig
[iface] [ipaddr]
[broadcast <addr>
|mtu
<value>|dynamic]
[broadcast <addr>
|mtu
<value>|dynamic]
Configures a network interface.
ping
<hostid>
Pings a remote host.
route
status
[if]
Displays the routing table.
add
<dest_addr|defaul
t>[/<bits>]
<gateway>
[<metric>]
t>[/<bits>]
<gateway>
[<metric>]
Adds a route.
addiface
<dest_addr|defaul
t>[/<bits>]
<gateway>
[<metric>]
t>[/<bits>]
<gateway>
[<metric>]
Adds an entry to the routing table for the
specified interface.
addprivate
<dest_addr|defaul
t>[/<bits>]
<gateway>
[<metric>]
t>[/<bits>]
<gateway>
[<metric>]
Adds a private route.
drop
<host addr> [/
<bits>]
<bits>]
Drops a route.
status
Displays IP statistic counters.
udp
status
Displays the UDP status.
rip
These are the Routing Information Protocol
commands.
accept <gateway>
Drops an entry from the RIP refuse list.
activate
Enables RIP.
merge [on|off]
Sets the RIP merge flag.
refuse <gateway>
Adds an entry to the RIP refuse list.
request <addr>
[port]
Sends a RIP request to the specified address
and port.
reverse [on|off]
RIP Poisoned Reverse.
status
Displays RIP statistic counters.
trace
Enables the RIP debug trace.
mode
Table 59 IP commands
Command
Description