2WIRE 1700HW User Manual

Page of 22
Gateway Installation and Support Guide
17
Appendix E: Back-Up Key Codes
In most cases, you will receive a key code from your ISP. This key code is used to activate the 2Wire 
gateway. If you did not receive a key code, you can use the key codes provided in the following table.
If your Internet Service Provider did not provide you with 
a user name, password, or IP address to set up your 
Internet connection, your broadband connection most 
likely uses DHCP (Dynamic Host Configuration Protocol) 
and you should use this key code.
52EU-2374-2262-22AT-B222
If your Internet Service Provider gave you a PPPoE 
username and password to set up your Internet 
connection, your broadband connection uses Point-to-
Point Protocol over Ethernet and you should use this key 
code.
52EU-2374-6262-22AS-B22Y
If your Internet Service Provider assigned you an IP 
address to set up your Internet connection, your 
broadband connection uses static IP (Internet Protocol) 
and  you should use this key code.
52EU-2374-2E66-22AS-B2TW
If your Internet Service Provider gave you a PPPoA 
username and password to set up your Internet 
connection, your broadband connection uses Point-to-
Point Protocol over ATM. In this case, you would use this 
key code and Microsoft Dial-up Networking to connect to 
the Internet.
52EU-2374-A222-22AS-B2QK