Panasonic WJ-SX 150 User Manual
37
Connect non-multiplex type cameras to the CAMERA IN
connectors 1 to 16. For cameras equipped with RS-485
communication facilities, connect the RS-485 cable as fol-
lows.
connectors 1 to 16. For cameras equipped with RS-485
communication facilities, connect the RS-485 cable as fol-
lows.
Check the camera addresses when using RS-485 cameras.
Operations from the system controller will be invalid if the
camera addresses are set improperly.
Operations from the system controller will be invalid if the
camera addresses are set improperly.
• Use addresses from 1 to 16 for individual cameras.
• Do not set the same address for more than one camera
• Do not set the same address for more than one camera
in an RS-485 chain.
• Before connecting the RS-485 camera(s) to DATA 1, 2
and/or 3, configure the system through WJ-SX150
Administrator Console.
Administrator Console.
■
Connection with the Camera Sites
Connect the data-multiplex type cameras (or camera site
equipment) to the CAMERA IN connectors 1 to 16 on the
matrix switcher's rear panel.
equipment) to the CAMERA IN connectors 1 to 16 on the
matrix switcher's rear panel.
Notes:
• Make sure that the cable length is less than 900 m
(3 000 ft) between the camera site and the unit when
using RG-59/U, BELDEN 9259 or equivalent cables.
using RG-59/U, BELDEN 9259 or equivalent cables.
• If you use locally procuring cables, it is important to use
only a data-grade cable, which is suitable for RS-485
communication (shielded 2-wire twisted cable).
communication (shielded 2-wire twisted cable).
• When the cable length is extended, cable compensa-
tion is available. (Refer to pp. 60 and 78.)
AUX
Alarm
Alarm
WJ-SX150 Matrix Switcher
CAMERA
1
1
2
2
3
3
DATA 3 DATA 2
OUT
IN
4
4
5
5
6
6
7
7
8
8
9
9
10
10
16
16
RS485(CAMERA)
DATA 1
2
4
RS485(CAMERA)
LINE
SELECT
CONNECTIONS