StarTech.com AP150WN1X1U Leaflet

Manual Revision: 01/27/2014

For the most up-to-date information, please visit: www.startech.com

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com

•  1 x Travel Router 

•  1 x USB Cable 

•  1 x RJ45 Cable 

•  1 x Carrying Pouch 

•  1 x Instruction Manu

•  Available USB port (or wall charger) for power

AP150WN1X1U

WPS mode is disabled by default because it requires a secured wireless network to be 

used. 

1. 

Once you have selected an operating mode and are connected to the 

web interface (details in the following sections of this manual), configure 

your desired wireless security protocol and key.

Off: No Wi-Fi signal

Solid: Wi-Fi signal broadcasting

Flashing: Activity

Off: No RJ45 connection detected

Solid: RJ45 connection detected

Flashing: Activity

Off: No power supplied to the device

Solid: Connected to a USB power source   

2. 

Enable WPS mode.

3. 

Once enabled, a single press of the button will activate it.

In order to reset the device to factory defaults:

Note: All previously configured settings will be deleted after performing a reset

1. 

Ensure the AP is connected to a power source.

2. 

Press and hold the reset button for 8 seconds, then release.

Please visit www.startech.com/AP150WN1X1U for full operating instructions and 

specifications

SSID: AP150WN1X1U

LAN IP Address: 192.168.16.254

Username / Password: admin / admin

In AP mode, the AP150WN1X1U acts as a wireless transmitter which adapts a wired 

network signal into WiFi, so that other wireless devices like smartphones and tablets 

within range can share the wired connection.

Widely used in: Hotel rooms, school dormitories, etc.

1. 

Adjust the switch on the device to AP Mode.

2. 

Connect one end of the included Ethernet cable to the RJ45 port of the AP, and 

the other to the hotel wall jack/switch.

3. 

Connect one end of the included USB cable to the USB port of the AP, and the 

other to a USB power source (e.g. laptop, USB wall charger, etc.).

4. 

Connect your wireless devices to the “AP150WN1X1U” SSID and open your web 

browser to access the Internet.

NOTE: If the hotel Internet connection requires a password or has a captive portal 

login, contact the front desk to obtain that information.

RJ45 Interface

WPS/Reset Button

Mode Selector Switch

USB Interface