Sony HKJ-101 User Manual

1-2 (E)

HKJ-101

1-2-1. To install HKJ-101 in J-H1

Remove the six M3 case stopper screws.

Remove the rear panel.
n
Store the removed rear panel in a safe place so as not
to lose it.

Insert the connector (CN601) on the DV-29 board into
the connector (CN41) on the CN-2478 board.
n
First, insert the connector (CN401) on the DV-29
board to the hole for i.LINK connector on the IF panel.
Then insert connector (CN601) to the connector on the
CN-2478 board.

Fix the DV-29 board to the IF panel and to the CN-
2478 board using the supplied screws (PWH2

x 5 : 2

screws, PSW2.6

x 5 : 3 screws).

n
When tightening the screws, tighten the screws PWH2
x 5 first of all screws.

Rear panel

M3 case stopper screws

M3 case stopper
screws

DV-29 board

CN-2478 board

PSW2.6

x 5

PSW2.6

x 5

PWH2

x 5

IF panel

CN601

CN41

CN401

Insert the CN-2478 board to the second slot from the
bottom of J-H1.

Strongly push the connector panel both from the right
and the left sides of the CN-2478 board so that the
connector on the CN-2478 board is securely inserted
into the connector on the MB-993 board.

Install the supplied rear panel for J-H1 using the six
M3 case stopper screws.
n
Tighten the screws in the state that the two dowels are
aligned with the holes (a) and (b) on the rear panel as
shown in the figure.

CN-2478 board

Hole (b)

Hole (a)

Dowel

J-H1 rear panel
(Supplied accessory)

M3 case stopper
screws