Siemens 5935 User Manual

You may position the Siemens broadband router at any convenient location where it will be well ventilated. Do 
not stack it with other devices or place it on the carpet. You can connect the router to an existing Ethernet port 
on your computer.

To connect the SpeedStream device via the Ethernet interface, your 
computer must have an Ethernet adapter (also called a network 
interface card, or NIC) installed. If your computer does not have this 
adapter, install it before proceeding further. Refer to your Ethernet 
adapter documentation for complete installation instructions. Once you 
verify installation of an Ethernet adapter, perform the following 
procedure to connect the router to your computer. 

1. With the PC powered off, connect the Ethernet cable to an 

Ethernet port on the router.

2. Connect the other end of the Ethernet cable to the Ethernet 

port on the PC. 

3. Connect the DSL cable (resembles a telephone cord) to the 

DSL port on the rear of the router. To reduce the risk of fire, 
use only 26 AWG gauge telecommunication cord to 
connect your DSL port on your router to a DSL telephone 
jack.

4. Plug the other end of the DSL cable into the phone jack.

5. Connect the power adapter to the rear of the router.

6. Plug the power adapter into the electrical wall outlet.

7. Flip the power switch on the router. 

8. Power on all connected computers. 

 You can now configure the TCP/IP settings as detailed in the 

 section.