Siemens S223 User Manual

User Manual                                                                               UMN:CLI 
SURPASS hiD 6615 S223/S323 R1.5 

A50010-Y3-C150-2-7619                                                                         185 

able of carrying double-tagged traffic. A trunk port is always connected to another trunk 
port on a different switch. Switching shall be performed between trunk ports and tunnels 
ports and between different trunk ports. 

 

Step 1 
If there is no SPVLAN Tag on received packet, SPVLAN Tag is added. 
SPVLAN Tag = TPID : Configured TPID 
VID : PVID of input port 

Step 2 
If received packet is tagged with CVLAN, the switch transmits it to uplink port changing to 
SPVLAN + CVLAN. When TPID value of received packet is same with TPID of port, it 
recognizes as SPVLAN, and if not as CVLAN. 

Step 3 
If Egress port is Access port (Access port is configured as Untagged), remove SPVLAN. If 
egress port is uplink port, transmit as it is. 

Step 4 
The hiD 6615 S223/S323 switch has 0x8100 TPID value as default and other values are 
used as hexadecimal number. 

 

Step 1 
Designate the QinQ port. 

 PORTS

Bridge 

Configures a qinq port. 
PORTS: selects port number qinq to be enabled 

 

Step 2 
Configure the same PVID with the VLAN of peer network on the designated qinq port. 

vlan pvid PORTS 

<1-4094> Bridge 

Configures a qinq port. 
PORTS: selects port number qinq to be enabled 
<1-4094>: VLAN ID 

To disable double tagging, use the following command 

 

 

Bridge 

Configures a qinq port. 
PORTS: a port qinq to be disabled 

 

When you configure Double tagging on the hiD 6615 S223/S323, consider the below at-
tention list.