Siemens S223 User Manual
UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
338 A50010-Y3-C150-2-7619
To delete a configured interface cost for OSPF, use the following command.
Command Mode
Description
no ip ospf cost
no ip ospf
A.B.C.D cost
Interface
Deletes a configured an interface cost for OSPF.
10.2.4.4
Blocking Transmission of Route Information Database
OSPF routing communicates through the LAS. Each routing information is saved internal
router as a datebase, but user can configure the specific interface to block the transmis-
sion of routing information saved in database to other router.
router as a datebase, but user can configure the specific interface to block the transmis-
sion of routing information saved in database to other router.
To block the transmission of routing information to other router, use the following com-
mand.
mand.
Command Mode
Description
ip ospf database-filter all out
ip ospf
A.B.C.D database-filter
all out
Interface
Blocks the transmission of routing information to other
router.
router.
To release a blocked interface, use the following command.
Command Mode
Description
no ip ospf database-filter
no ip ospf
A.B.C.D database-
filter
Interface Releases
a
blocked interface.
10.2.4.5
Routing Protocol Interval
Routers on OSPF network exchange various packets, about that packet transmission,
time interval can be configured in several ways
time interval can be configured in several ways
The following lists are sort of time interval which can be configured by user:
•
Hello Interval
OSPF router sends Hello packet to notify existence of itself. Hello interval is that
packet transmission interval.
•
Retransmit Interval
When router transmits LSA, it is waiting for approval information come from receiver.
In this time, if there is no answer from receiver for configured time, the router trans-
mits LSA again. Retransmit-interval is configuration of the time interval between
transmission and retransmission.
•
Dead Interval
If there is no hello packet for the configured time. The router perceives other router is
stopped working. Dead interval is configuration of the time interval which perceives
other router is stopped operating.
•
Transmit Delay
When a router transmits LSA, the traffic can be delayed by status of communications.