Siemens S223 User Manual

UMN:CLI                                                                                                                                                              User  Manual 

SURPASS hiD 6615 S223/S323 R1.5 

342                                                                         A50010-Y3-C150-2-7619 

To delete a configured router communicated by non-broadcast type, use the following 
command. 

 A.B.C.D cost [<1-65535>] 

 A.B.C.D priority [<0-255>] 

  A.B.C.D  priority  poll-interval [<1-

65535>] 

 A.B.C.D poll-interval [<1-65535>] 

  A.B.C.D  poll-interval  priority [<0-

255>] 

Router 

Deletes a configured neighbor router of 
NBMA type. 

 

Router configuration on OSPF network includes Area configuration with each interface, 
network. Area has various and special features. It needs to be configured pertinently to 
make effective management on whole of OSPF network. 

OSPF network defines several router types to manage the Area. ABR (Area Border 
Router) is one of the router types to transmit information between Areas.   

ASBR (Autonomous System Border Router) is using OSPF on oneside and using other 
routing protocol except for OSPF on other interface or Area. ASBR exchanges area in-
formation between different routing protocols. 

Area types are various. The most principle Area types are Stub Area and NSSA (Not So 
Stubby Area). 

 

OSPF routers in specific Area can configure authentication for security of routing informa-
tion. Encoding uses password based on text or MD5. To set password on interface as-
signed Area, use the ip ospf authentication-key and ip ospf message-digest-key 
commands in interface mode, see Section 10.2.4.1 for more information. 

To configure authentication information for encoding, use the following command. 

 <0-4294967295> authenti-

 

Configures authentication information which is based 
on text encoding in the Area. 

 <0-4294967295> authenti-

 message-digest 

Router 

Configures authentication information which is based 
on MD5 encoding in the Area. 

 

To delete configured authentication information for encoding, use the following command. 

 <0-4294967295> authen-

 

Router 

Deletes configured authentication information.