Siemens S223 User Manual
User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 73
5 Port
Configuration
It is possible for user to configure basic environment such as auto-negotiate, transmit rate,
and flow control of the hiD 6615 S223/S323 port. Also, it includes instructions how to con-
figure port mirroring and port as basic.
and flow control of the hiD 6615 S223/S323 port. Also, it includes instructions how to con-
figure port mirroring and port as basic.
5.1 Port
Basic
It is possible to configure default environment of port such as port state, speed. To con-
figure port, you need to open Bridge Configuration mode by using the command, bridge,
on Global Configuration mode. When you begin Bridge Configuration mode, system
prompt will be changed from SWITCH(config)# to SWITCH(bridge)#.
figure port, you need to open Bridge Configuration mode by using the command, bridge,
on Global Configuration mode. When you begin Bridge Configuration mode, system
prompt will be changed from SWITCH(config)# to SWITCH(bridge)#.
SWITCH(config)# bridge
SWITCH(bridge)#
The hiD 6615 S223/S323 have 12 electrical and optical combo 100/1000Base-X Ethernet
ports. The direction to configure each port is different depending on its features. Read the
below instruction carefully and follow it before you configure.
ports. The direction to configure each port is different depending on its features. Read the
below instruction carefully and follow it before you configure.
Refer to below figure for front interfaces of hiD 6615 S223/S323.
RUN
RPU
DIAG
RX
LNK
ACT
MGMT
CONSOLE
TX
1
1
2
3
4
5
6
7
8
9
10
11
12
L/A
S323
1 G
2 3 4 5 6 7 8 9 10 11 12
SURPASS
hiD 6615
Fig. 5.1
hiD 6615 S223/S323 Interface
To display the configuration of the physical port, use the following command.
Command Mode
Description
show port
[PORTS]
Enable
Global
Bridge
Bridge
Shows port configuration.
When you use the command, show port command, if you input letter at port-number, the
message, “% Invalid port: port'” will be displayed, and if you input wrong number, the
message, “% Invalid range: 100 [1-18]” will be displayed.
message, “% Invalid port: port'” will be displayed, and if you input wrong number, the
message, “% Invalid range: 100 [1-18]” will be displayed.
SWITCH(bridge)# show port port
%Invalid port: port
SWITCH(bridge)# show port 100
%Invalid range: 100 [1-18]
SWITCH(bridge)#
5.1.1
Selecting Port Type
User should select port type due to the hiD6615 S223/S323 switch ports have two types
(RJ45 and SFP). To select port type, use the following command.
(RJ45 and SFP). To select port type, use the following command.