Siemens 4100 Series User Manual

5 

Chapter 2 

Physical Installation 

•  DSL service and an Internet access account from an Internet Service Provider (ISP). 
•  Network cables for the device you intend to connect to the Router. Use standard CAT5 Ethernet 

cables with RJ45 connectors. 

•  TCP/IP network protocol must be installed on all computers. 
•  For USB connection to the Router, the following operating systems are supported (if your Router 

model supports USB): 

− Windows 

98, 

98SE 

− Windows 

2000 

−  Windows ME or XP 
−  Mac OS versions 8.6 through 10.2.4 

Note: Your configuration may vary slightly from the instructions and illustrations in this chapter. Refer to 
your service provider’s documentation, or contact them with questions regarding your specific 
configuration. 

You may position the SpeedStream Router at any convenient location in your office or home. No special 
wiring or cooling requirements are needed; however, you should comply with the safety guidelines 
specified in the 

 section. 

1. 

2. 

3. 

4. 

. 

5. 

. 

6.  Reboot the computer if prompted. Whenever you are required to reboot the Router, allow five 

seconds between turning off the unit and powering it back on. 

2