Siemens 5890 User Manual
SIEMENS 5890 DSL Router
User’s Guide
User’s Guide
Chapter 3 Easy Setup
Select Protocol
SIEMENS
20
Point-to-Point Protocol over ATM (LLC Encapsulation)
If you selected Point-to-Point Protocol over ATM (LLC Encapsulation) from the Wan Interface page, the
Point-to-Point Protocol page is displayed when you click Next.
Point-to-Point Protocol page is displayed when you click Next.
To configure Point-to-Point Protocol:
1. Enter PPP User Name and Password to use for authentication when establishing a WAN connection using
PPP protocol.
2. Select one or more of the following PPP Networking options:
•
Bridging Enabled:
Forward all traffic for remote hosts that is not routed to the WAN (non-IP). If bridging is enabled, you can
optionally select Only bridge PPPoE traffic. If selected, only PPPoE traffic is bridged; all other traffic is
stopped.
Forward all traffic for remote hosts that is not routed to the WAN (non-IP). If bridging is enabled, you can
optionally select Only bridge PPPoE traffic. If selected, only PPPoE traffic is bridged; all other traffic is
stopped.
3. IP Routing Enabled:
Route all IP traffic to remote hosts.
4. If you enabled IP routing, select one of the following methods for configuring IP routing:
•
Obtain configuration automatically from WAN
IP routing parameters are obtained from the WAN.
IP routing parameters are obtained from the WAN.
•
Configure IP Routing manually
IP routing parameters are set manually. If you select this options, you must the Source WAN IP
Address, Subnet Mask, and Default Gateway.
IP routing parameters are set manually. If you select this options, you must the Source WAN IP
Address, Subnet Mask, and Default Gateway.