Siemens 2602 User Manual

Use unshielded or shielded twisted-pair Ethernet cable with RJ-45 plugs to connect the broadband 
modem directly to the WAN port on the SpeedStream 2602. Use either straight-through or crossover 
cable depending on the port type provided by the modem (see Appendix B, “Cables”). 

4. Connect the power adapter and power up the router, modem and network computers. Plug the 

power adapter into the power socket on the SpeedStream 2602, and plug the other end into a power 
outlet. Check the Power indicator on the front panel to be sure it is on. If the Power indicator does not 
light up, refer to Appendix A, “Troubleshooting.” 

5. Verify the port status. Confirm that all connections are successful by checking the power and port 

status indicators as shown in the following table.

6. Configure the SpeedStream 2602. Configure the SpeedStream 2602 as detailed in Chapter 3, 

“Configuring the SpeedStream 2602.”

7. Configure TCP/IP. Configure the TCP/IP protocol on your network computers as detailed in Chapter 

4, “Configuring Client TCP/IP.” If TCP/IP is not on your system, this chapter also includes  
installation instructions.

8. Reboot the computer when prompted.

Power

n/a

Green

On 

SpeedStream 2602 is receiving power.

WAN

n/a

Green

On 

The WAN port has established a valid network connection.

Flashing 

The WAN port is transmitting or receiving traffic.

LAN

- Link/Act

1-2

Green

On 

The indicated LAN port has established a valid network 
connection.

Flashing

The indicated LAN port is transmitting or receiving traffic.

- 10/100

1-2

Amber

On

The indicated LAN port is operating at 100 Mbps.

Flashing

The indicated LAN port is operating at 10 Mbps.