Sony BKP-7933 User Manual
1-46 (E)
BKP-7933
1-10-2. Controlling a Waveform Monitor
A waveform monitor can be controlled from the MSU via the I/O PORT connector of the BKP-7933, by
setting the switches on the IF-689 board of the BKP-7933.
setting the switches on the IF-689 board of the BKP-7933.
n
The following setting is effective to control a waveform monitor from the MSU that is connected to the
IF-480 board of the CNU-700 in which the BKP-7933 is installed. A waveform monitor cannot be
The following setting is effective to control a waveform monitor from the MSU that is connected to the
IF-480 board of the CNU-700 in which the BKP-7933 is installed. A waveform monitor cannot be
controlled by the MSU that is connected to the optional IF-480 board (CNU IF board BKP-7930).
1.
Set the switch S2-2 on the IF-689 board to OFF.
When it is set to OFF, remote control mode of the waveform monitor is selected.
When it is set to OFF, remote control mode of the waveform monitor is selected.
2.
Set the switch S2-3 on the IF-689 board in accordance with a waveform monitor in use.
HD ANALOG system waveform monitor (such as Tektronix 1730HD)
HD ANALOG system waveform monitor (such as Tektronix 1730HD)
→
ON
RECALL system waveform monitor
→
OFF
1-10. Using the BKP-7933 in the HD System
IF
RX TX
S-BUS
S-BUS ID No.
S2
CNU GROUP No.
+5
(Component side/A side)
IF-689 board