Siemens S323 User Manual

User Manual                                                                               UMN:CLI 
SURPASS hiD 6615 S223/S323 R1.5 

A50010-Y3-C150-2-7619                                                                         109 

To set an SNMP trap host, use the following command. 

 [COMMUNITY] 

 [COMMUNITY] 

Specifies IP address of an SNMP trap host. 

 [COMMUNITY] 

Global 

Specifies IP address of SNMP information trap host. 

 

You need to configure an SNMP trap host with the snmp trap2-host command, if you 
manage the switch via the ACI-E. 

To delete a specified SNMP trap host, use the following command. 

 IP-ADDRESS 

no snmp trap2-host IP-ADDRESS

 

Deletes a specified SNMP trap host. 

no snmp inform-trap-host IP-ADDRESS

 

Global 

Deletes a specified information trap host. 

 

You can set maximum 16 SNMP trap hosts with inputting one by one. 
 

The following is an example of setting an SNMP trap host. 

SWITCH(config)# snmp trap-host 10.1.1.3 

SWITCH(config)# snmp trap-host 20.1.1.5 

SWITCH(config)# snmp trap-host 30.1.1.2 

SWITCH(config)# 

 

To select an SNMP trap-mode, use the following command. 

  {alarm-report | 

} 

Global 

Selects SNMP trap-mode according to user’s network 
environment. ( alarm-report or event) 

 

•

 

 is set by default. It means that Dasan trap OID will be used upon 

 

sending the trap if the trap-mode is “event”   

•

 

will be used form SLE MIB OID which is Siemens private 

 OID. 
 

In order to manage hiD 6615 S223/S323 using ACI-E, the trap-mode must be set as 
“alarm-report”. Otherwise, ACI-E would not recognize any traps set from the hiD 6615 
S223/S323.