Siemens S323 User Manual

User Manual                                                                               UMN:CLI 
SURPASS hiD 6615 S223/S323 R1.5 

A50010-Y3-C150-2-7619                                                                         145 

To delete a specified rule action (no-match), use the following command. 

Rule 

Deletes a specified rule action. 

 

After configuring rule using the above commands, apply it to the system with the following 
command. If you do not apply the rule to the system, all specified rules will be lost. 

To save and apply a rule, use the following command. 

Rule 

Applies a rule to the system. 

 

1.  The switch performs a detailed plausibility check and rejects the rule if the 
 

configuration is incomplete, contains bad or unsupported values or conflicts to other 

 

rules. In this case, the switch informs about the reason and the operator may correct 

 the 

values 

2.  The switch may reject a rule with the message “% Already exist rule” allthough the 
 

name will not be listed by command, show rule. Unfortunately, the entered name in 

 

this case interferes with the name of an internally managed rule. 

 

 

3.  All previously entered values remain valid after successful (or unsuccessful) 
 

execution of command, apply. That is, if several rules being different only in one 

 

value should be created, then only the one changed value needs to be entered again. 

 

To modify a rule, use the following command. 

 NAME modify 

Global 

Modifies a rule, enter a rule name. 

 

To delete a rule, use the following command. 

 [NAME] 

Global 

Deletes a rule, enter a rule name optionally.