Siemens S323 User Manual

UMN:CLI                                                                                                                                                              User  Manual 

SURPASS hiD 6615 S223/S323 R1.5 

216                                                                         A50010-Y3-C150-2-7619 

To delete the edge port mode, use the following command. 

 stp edge-port PORTS Bridge 

Deletes port edge mode: 
PORTS: select the port number. 

 

To display the configuration after configuring STP, RSTP, and MSTP, use the following 
command. 

Shows the configuration of STP/RSTP/MSTP. 

Shows the configuration when it is configured as 
MSTP. 

 MSTID-RANGE 

Shows the configuration of specific Instance, enter the 
instance number. 

 MSTID-RANGE {all 

| PORTS} [detail] 

Enable 

Global 
Bridge 

Shows the configuration of the specific Instance for the 
ports: 
MSTID_RANGE: select the MST instance number. 
all: select all ports. 
PORTS: select port number. 
detail: show detail information (as option). 

 

In case STP or RSTP is configured in the SURPASS hiD 6615 S223/S323, you should 
configure MSTID-RANGE as 0. 
 

To display a configured MSTP of the switch, use the following command. 

 {current | 

} 

Enable 

Global 
Bridge 

Shows the MSTP configuration identifier: 
current: shows the current configuration as it is used to 
run MST. 
pending: shows the edited configuration. 

 

For example, after the user configures configuration ID, if you apply it to the switch with 
stp mst config-id commit

 command, you can check configuration ID with the show stp 

 command. 

However, if the user did not use the stp mst config-id commit command in order to ap-
ply to the switch after configuration, the configuration could be checked with the show 
stp mst config-id pending

 command.