Siemens S323 User Manual

User Manual                                                                               UMN:CLI 
SURPASS hiD 6615 S223/S323 R1.5 

A50010-Y3-C150-2-7619                                                                         377 

 

Reboot the system with the new system software using the following command. 

 [os1 | os2] Boot 

Reboots the system with specified system software. 
os1 | os2: the area where the system software is stored

 

If the new system software is a current standby OS, just exit the boot mode, then the in-
terrupted system boot will be continued again with the new system software. 

To exit the boot mode, use the following command. 

 

Boot 

Exits the boot mode. 

 

The system software of the hi can be upgraded using FTP. This will allow network or sys-
tem administrators to remotely upgrade the system with the familiar interface. 

To upgrade the system software using FTP, perform the following step-by-step instruction: 

 

Connect to the hiD 6615 S223/323 with your FTP client software. To login the system, you 
can use the system user ID and password. 

Note that you must use the command line-based interface FTP client software when up-
grading the hiD 6615 S223/323. If you use the graphic-based interface FTP client soft-
ware, the system cannot recognize the upgraded software. 

 

Set the file transfer mode to the binary mode using the following command. 

 

FTP 

Sets the file transfer mode to the binary mode. 

 

 

Enable to print out the hash marks as transferring a file using the following command. 

 

FTP 

Prints out the hash marks as transferring a file. 

 

 

Uploads the new system software using the following command. 

 FILENAME {os1 | os2} FTP 

Uploads the system software. 
FILENAME: system software file name 
os1 | os2: the area where the system software is stored