Sierra Wireless EV-DO User Manual
Configuration Commands
Rev 3.0B Feb.08
144
•
n=minutes
*TPORT=n
Sets or queries the port used for the AT Telnet server. If 0 is
specified, the AT Telnet server will be disabled. The default
value is 2332.
specified, the AT Telnet server will be disabled. The default
value is 2332.
•
n=0 : Disabled.
•
n=1‐65535
Tip: Many networks have the ports below 1024 blocked. It is recom-
mended to use a higher numbered port.
mended to use a higher numbered port.
*TQUIT
Disconnects the telnet session. Not available in AceManager..
Low Power
The PinPoint‐E will put itself into a low power using mode
when configured events occur. Low Power mode is essentially
a standby mode which uses minimal power while being ready
to “come alive” quickly.
when configured events occur. Low Power mode is essentially
a standby mode which uses minimal power while being ready
to “come alive” quickly.
Figure 1-15: AceManager : Low Power
DTRP=n
Set or query the DTR power control. See also PTMR.
•
n=0 : Ignore DTR for power control.
•
n=1 : Enter low power mode when DTR is low.
•
n=2 : Enter low power mode when DTR is high.
PTMR=n
Number of minutes after one of the power down events (VTLG
or DTRP) happens until the PinPoint‐E enters the low power
mode. If DTRP and VLTG are both 0 (zero), this setting does
nothing.
or DTRP) happens until the PinPoint‐E enters the low power
mode. If DTRP and VLTG are both 0 (zero), this setting does
nothing.