Sierra Wireless EV-DO User Manual
Data Communication and Host Modes
Rev 3.0B Feb.08
60
PassThru Mode allows only specific AT commands. Some
ALEOS commands will be unavailable when the PinPoint‐E is
in PassThru mode. The commands usable also depend heavily
on the modem model number (found on the label on the top of
the PinPoint‐E).
ALEOS commands will be unavailable when the PinPoint‐E is
in PassThru mode. The commands usable also depend heavily
on the modem model number (found on the label on the top of
the PinPoint‐E).
Note: Some internal hardware requires upwards of 20 seconds
before AT commands can be entered, so be patient if there seems to
be no response to AT commands.
before AT commands can be entered, so be patient if there seems to
be no response to AT commands.
Telnet Mode
In AceManager you can configure Telnet operation.
Figure 7-3: AceManager : S0
If you need to change the port for Telnet (for example, you
have the default port blocked on your firewall), the option is
on the Other tab. The default telnet port is 2332. You can also
change the Telnet timeout, if the connection is idle, default 2
minutes.
have the default port blocked on your firewall), the option is
on the Other tab. The default telnet port is 2332. You can also
change the Telnet timeout, if the connection is idle, default 2
minutes.
Figure 7-4: AceManager : Other - *TPORT, *TELNETTIMEOUT.
Serial Modes
PPP
In PPP mode, the PinPoint‐E acts as a PPP server, providing an
IP address, and DNS servers (if available) to the connected
device or computer.
IP address, and DNS servers (if available) to the connected
device or computer.