Siemens CP 243-2 User Manual
Command Interface
5-41
SIMATIC NET CP 243-2 AS-i Master
C79000-G8976-C142/02
C79000-G8976-C142/02
12
0
Parameter slave 12B
Parameter slave 13B
12
1
Parameter slave 14B
Parameter slave 15B
12
2
Parameter slave 16B
Parameter slave 17B
12
3
Parameter slave 18B
Parameter slave 19B
12
4
Parameter slave 20B
Parameter slave 21B
12
5
Parameter slave 22B
Parameter slave 23B
12
6
Parameter slave 24B
Parameter slave 25B
12
7
Parameter slave 26B
Parameter slave 27B
12
8
Parameter slave 28B
Parameter slave 29B
12
9
Parameter slave 30B
Parameter slave 31B
12
10
Flag 1
12
11
Flag 2
Flag 1
Flag 2
Bit Number
Meaning
Bit Number
Meaning
0
OFFLINE_READY
0
OFFLINE
1
APF
1
INTERNAL
2
NORMAL_MODE
2
EEPROM_OK
3
CONFIG_MODE
3
AUTO_ADDR_ENABLE
4
AUTO_ADDR_AVAIL
4
PERIPHERY_FAULT
5
AUTO_ADDR_ASSI_GN
5
reserved
6
LDS_0
6
reserved
7
CONFIG_OK
7
MPO startup
Flags whose values modify the AS-i master mode are shown on a gray
background.
background.
The values of the other flags have no significance for the ’store total configuration’
command and cannot be modified on the AS-i master with this call.
command and cannot be modified on the AS-i master with this call.
Only the gray shaded flags can be modified.
CONFIG_MODE
The entry ‘0’ means that the CP 243-2 changes to the protected mode after
executing the command. The entry ‘1’ means that the CP continues in the
configuration mode.
executing the command. The entry ‘1’ means that the CP continues in the
configuration mode.
0
The AS-i master starts up in the protected mode
on completion of the job.
on completion of the job.
1
The AS-i master starts up in the configuration mode
on completion of the job.
on completion of the job.
AUTO_ADDR_ENABLE
’0’ means that the automatic address programming is disabled, ’1’ means
that the automatic address programming is enabled.
that the automatic address programming is enabled.
0
Automatic address programming disabled.
1
Address programming enabled.