Dynalink RTA1320 User Manual

Page of 137
                         
S
S
a
a
f
f
e
e
t
t
y
y
 
 
a
a
n
n
d
d
 
 
P
P
r
r
e
e
c
c
a
a
u
u
t
t
i
i
o
o
n
n
 
 
 
For Installation 
… 
Use only the type of power source indicated on the marking labels. 
… 
Use only power adapter supplied with the product. 
… 
Do not overload wall outlet or extension cords as this may increase the 
risk of electric shock or fire. If the power cord is frayed, replace it with a 
new one. 
… 
Proper ventilation is necessary to prevent the product overheating. Do 
not block or cover the slots and openings on the device, which are 
intended for ventilation and proper operation. It is recommended to 
mount the product with a stack. 
… 
Do not place the product near any source of heat or expose it to direct 
sunlight.  
… 
Do not expose the product to moisture. Never spill any liquid on the 
product. 
… 
Do not attempt to connect with any computer accessory or electronic 
product without instructions from qualified service personnel. This may 
result in risk of electronic shock or fire. 
… 
Do not place this product on unstable stand or table. 
For Using 
… 
Power off and unplug this product from the wall outlet when it is not in 
use or before cleaning. Pay attention to the temperature of the power 
adapter. The temperature might be high. 
… 
After powering off the product, power on the product at least 15 
seconds later. 
… 
Do not block the ventilating openings of this product. 
… 
When the product is expected to be not in use for a period of time, 
unplug the power cord of the product to prevent it from the damage of 
storm or sudden increases in rating. 
For Service 
Do not attempt to disassemble or open covers of this unit by yourself. Nor 
should you attempt to service the product yourself, which may void the user’s 
authority to operate it. Contact qualified service personnel under the following 
conditions: 
… 
If the power cord or plug is damaged or frayed. 
… 
If liquid has been spilled into the product. 
… 
If the product has been exposed to rain or water. 
… 
If the product does not operate normally when the operating instructions 
are followed. 
… 
If the product has been dropped or the cabinet has been damaged. 
… 
If the product exhibits a distinct change in performance.   
Caution 
… 
Any changes or modifications not expressly approved by the party 
responsible for compliance could void the authority to operate 
equipment. 
 
                                                                                                                                                                                       
III