GarrettCom 6K32FR User Manual

Magnum 6K32F/FR/FC/FRC Managed Switch Installation and User Guide (05/08) 

modules. Please check the ordering information Sec.1.2 for all the various P6K PoE 

modules option. 

The LEDs on 6KP8-RJ45- PoE module are slightly different compared to 

regular (non-PoE) RJ-45 modules as shown in Fig 2. When the PoE port is in use, the 

PoE LED is ON when connected properly to an 803.af compliant PD device on that port. 

When non-PoE devices are connected, the PoE LED is OFF. Operation of Ethernet data 

traffic is not affected by PoE. 

LINK and ACTIVITY LEDS are combined on the PoE modules into one LED 

that is marked as LINK/ACT, as shown in the diagram. 

The combo six-port modules are combinations of copper and fiber media, 

available as four 10/100 switched RJ-45 copper ports and two 100Mb switched multi-

mode fiber ST, SC or single mode SC or Long Reach SC ports.  For ports numbering, 

ports 1,3,5,7 are copper, ports 2 and 6 are fiber, ports 4 and 8 are not present.   

The four RJ-45 ports operate just like the 8-port copper module with the auto-

cross (MDIX) feature to eliminate the use of cross-over cables, and the two fiber ports 

operate at 100Mbps full-duplex (default). User mode control per port through the MNS 

software is also the same. 

On Magnum “4+2” Combo modules, there are four LED’s for each RJ-45 port, 

which indicate status the same as described for the 6KP8-RJ45 in Section 2.2.3 above. 

The fiber port’s LEDs indicate status the same way as described for the SFF fiber 

modules in Section 2.2.2 above.  Color-coding on the panel of the module shows which 

LEDs belong to which port.   

The Magnum Combo six-port modules are also available with 4@ MTRJ 

100Mb mm SFF fiber and 2@10Mb fiber mm ST ports, and with 4@ RJ45 10/100 

copper and 2@10Mb fiber mm ST ports. 

The 4@ RJ-45 + 2@ 10 Mb ST operation of the SFF fiber and the RJ-45 half 

of the module is as described for those port types above.  For detailed information about 

10Mb mm ST fiber half of the module, see Section 2.2.5. 

 

16 

.

.