Dynex DX-E401 User Manual
56
Troubleshooting
2 Click
Network
, then click
Built-in Ethernet
in the Show list.
3 Click
Using DHCP
on the
Configure
list, then click
Apply Now
. The IP
address, subnet mask, and the router's IP address appear in a few seconds.
Checking the wireless connection by pinging in
Windows XP and Windows 2000
Windows XP and Windows 2000
To check the wireless connection by pinging in Windows XP and Windows 2000:
1 From the Windows Desktop, click
Start
(in the lower left corner of your
screen), click
Run
, type
cmd
in the box, then click
OK
.
The Command Prompt
screen opens.
2 Type
ping xxx.xxx.xxx.xxx
, where xxx is the IP address of the router.
A good wireless connection shows four replies from the router.
Troubleshooting
This section provides solutions to problems that can occur during the installation
and operation of the DX-E401 Cable/DSL Router. It covers various aspects of the
network setup, including the network adapters. Read the following if you are
having problems.
and operation of the DX-E401 Cable/DSL Router. It covers various aspects of the
network setup, including the network adapters. Read the following if you are
having problems.