Gateway 9315 User Manual

www.gateway.com

If nothing happens when you press the power button:

■

Make sure that the power cable is plugged in securely and that your surge protector 
(if you are using one) is plugged in and turned on.

■

Make sure that the monitor is connected to the server, plugged into the power 
outlet or surge protector, and turned on. You may also need to adjust the monitor’s 
brightness and contrast controls.

■

Wait 5-10 seconds after plugging the power cord into the server before pressing 
the power button. This allows the internal monitoring and control hardware to 
initialize.

■

If you cannot find the cause of the power loss, contact Gateway Customer Care. 
For more information, see 

The first time you turn on the server, any pre-installed operating system may begin 
asking you for configuration settings. See your operating system’s documentation for 
instructions on configuring advanced settings for your specific network.

When you turn on your server, the power-on self-test (POST) routine checks the server 
memory and components. If POST finds any problems, the server displays error messages. 
Write down any error messages that you see, then see 

 and 

 for troubleshooting information.

Green (steady on)

The server is turned on.

Green (blinking)

The server is in sleep mode.

Off

The server is turned off.

Green (steady on)

The server is operating normally.

Green (blinking)

The server is operating in a degraded condition.

Orange (steady on)

The server is in a critical or unrecoverable condition.

Orange (blinking)

The server is in a noncritical condition.

Off

POST failure or full system stop.