Gateway 9315 User Manual
49
www.gateway.com
Removing a diskette drive from the converted hard
drive bay
drive bay
To remove a diskette drive from the converted drive bay:
1
Follow the instructions in
. Make
sure that you turn off the server, then unplug the power cord and all other cables
connected to the server.
connected to the server.
2
Follow the instructions in
.
3
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
4
Pull up on the top of the connector on the backplane marked “Floppy Con” to release
the flat flex cable.
the flat flex cable.
5
Push in on the lever at the back of the drive carrier to release the drive carrier from
the drive bay, then slide the diskette drive carrier out through the front of the server.
the drive bay, then slide the diskette drive carrier out through the front of the server.
6
Pull up on the top of the connector on the back of the diskette drive and remove the
flat flex cable.
flat flex cable.
7
Remove the four screws securing the rails to the carrier, then remove the rails.
8
Remove the two screws securing the diskette drive in the carrier, then slide the drive
out of the carrier.
out of the carrier.
9
Follow the instructions in
if you are installing a new diskette drive.
- OR -
Follow the instructions in
to install
a hard drive.
10
Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
11
Follow the instructions in
12
Reconnect all power cords and peripheral device cables, then turn on the server.
Caution
The diskette drive is not hot-swappable. Before installing or removing
the drive, make sure that power is turned off and the power cord is
unplugged.
the drive, make sure that power is turned off and the power cord is
unplugged.