Gateway 9315 User Manual
82
www.gateway.com
Installing or replacing the hot-swap
backplane
backplane
Your server may not have a hot-swap backplane. If your server was ordered with fixed
drives, it will not have a hot-swap backplane.
drives, it will not have a hot-swap backplane.
To install or replace the hot-swap backplane:
1
Follow the instructions in
. Make
sure that you turn off the server, then unplug the power cord and all other cables
connected to the server.
connected to the server.
2
Remove the bezel by unlocking it, then pulling it straight off the front of the chassis.
3
Follow the instructions in
4
Follow the instructions in
5
Remove all drives and drive carriers by following the instructions in
. Make note of which bay you remove each drive
from.
If you are installing a hot-swap backplane for the first time, go to
. Otherwise
go to the next step.
6
Disconnect all cables from the backplane.